Equipment & Services
Hydro Jetting



We provide hydro jetting services which are also known as high pressure water jetting service. The process uses highly pressurized water from 3,000psi to 40,000psi to clean and remove any unwanted construction debris, rust, mill-scale from newly installed pipeline and even cold cut materials in any open or enclosed areas that are difficult to access. At 4,000psi, hydro jetting systems has the power to burst open the toughest blockages and at the same time scours the full diameter of the pipe, flushing debris, leaving a clear surface. Extremely high pressure systems with 40,000psi and above are used for concrete cutting. Generally most hardened deposits respond better to higher pressures, and softer buildup are best removed with higher flows.


These techniques have been used in practically every industry especially in cleaning of internal and external walls of pipelines, heat exchanger, boiler tubes, air fin coolers, tank, vessel, drainage etc. Hydro jetting cuts away clogs and slugs to prepare surface materials for repainting and removes grease build-up, rust, rubber, chemicals or other heavy build up without causing damage to the surface below it.


One of the major advantages for hydro jetting over other cleaning abrasives (such as silica sand, coal or smelter slag, metallic, synthetic, organic nut shells or fruit kernels) is its ability to contain, capture, filter and reuse the water. This eliminates waste water and contaminants after the cleaning.


Our service includes provision of hydro jetting systems, hoses, standard or rotating nozzles and specialists to perform the cleaning. Properly sized high pressure system will be matched according to various project requirements.


© 2013 SPCO HOLDINGS.  |  Terms & Conditions  |  Privacy  |  Sitemap